[H-GEN] Configuring Linux for Bigpond

[Rick Phillips]

[ Humbug *General* list - semi-serious discussions about Humbug and     ]
[ Unix-related topics. Posts from non-subscribed addresses will vanish. ]


> Secondly, The modem you speak of is a Controllerless modem, or winmodem, Up
> until recently there were no drivers(as far as I'm concerned, as I spent
> long hours searching for them) but finally Conexant must have seen the
> demand for them, and produced them, so bring up your favourite search engine
> and start looking - Because they are there, and I can Guarantee they work(I
> have used them) One note to watch out for, there are two different types of
> Controllerless Conexants, there is the HSF and the HCF, I COULD NOT get the
> HSF driver to run my HSF modem, but I found the HCF drivers[1] ran it
> without a hitch(for many months :)).
> 
All of the info given about "winmodems" is correct.  They can work and
here is a very good site for Conexant modems.  I have used them and the
drivers from this site and they work but as said above, be aware of the
difference between HCF and HSF.

http://www.mbsi.ca/cnxtlindrv/

Regards,

Rick Phillips
-- 
Tymling Group of Companies
PO Box 97, Cooroy Q 4563

Sunstate Stamps Ph (07) 5442 6800 Fax (07) 5442 6416
Email rickp at sunstatestamps.com.au

Suncoast Technical Ph (07) 5442 5423 Fax (07) 5442 6416
Email rickp at suntech.net.au




--
* This is list (humbug) general handled by majordomo at lists.humbug.org.au .
* Postings to this list are only accepted from subscribed addresses of
* lists 'general' or 'general-post'.  See http://www.humbug.org.au/