[H-GEN] router woes (redhat specific?)

[Tim Kent]

[ Humbug *General* list - semi-serious discussions about Humbug and     ]
[ Unix-related topics. Posts from non-subscribed addresses will vanish. ]

Hey there

Redhat kernel-source RPM has the .config files you're after if you just want to work on building a single module.  I used these for creating my freeswan kernel module RPMs without having to reboot the box (after patching the Makefile to get make menurpm working!).

For doing 'telnet blah' or whatever, if you've just got a couple of boxes you could do it the 'old way' and use the /etc/hosts file.

Regards
Tim

Tim Kent
Systems Administrator
Vector Networks Pty Ltd
Phone: +61 7 3236 9328
Fax: +61 7 3236 9209

>>> bmatthewtaylor at yahoo.co.uk 07/12/02 12:20pm >>>
Had a go at configuring a router from a basic 'server' install using 
redhat 7.3. (view to using 'router' as router/fileserver/occasional 
spare workstation for guests)

2 nics installed & configured no problem. eth1 set to 192.168.1.1 at 
boot, eth0 for adsl using roaring penguin on Telstra adsl. (problem - 
more below)

Read the DHCP mini howto, installed dhcpd, got it running and clients 
connecting no problem using pump or dhcpcd.

Read the IP Masquerade howto, discovered kernel module ip_tables appears 
to be incorrectly configured. This appears the same on 2 redhat 7.3 
boxes & 1 Redhat 7.2, do others have this problem?

I know I should be able to re-compile the kernel. The major hangup I 
seem to hit is knowing which options to select to replicate the 
distribution kernel. ie: if lsmod shows kernel module '8139too' (a nic 
module I think?) how do I check my kernel configure process will create 
that module?

[yes I've read the Module-HOWTO & Kernel-HOWTO tho I'm sure I've missed 
the obvious solutions, reading again...]

Using IPChains seems to be the 'easiest' solution, but I'd much rather 
'do it right'. Sample rulesets for either IPChains or IPTables would be 
appreciated.

the attached file 'routerInfo' contains output from uname -a, ifconfig, 
lsmod, and insmod ip_tables



The 'problem' I'm having with adsl has me baffled, previous 
configurations on standalone box never presenting a problem.

adsl-setup runs through usual enter username etc etc.

adsl-start yields
/sbin/adsl-start: line 217: 2344 Terminated                    $CONNECT 
"$@" >/dev/null 2>&1

pppoe-sniff  gave me
'great!, it looks like a standard PPPoE service.'

? ideas on what to look for/how?

also, when I ssh between boxes it is slow (3-4 secs at least), ping 
times are less than 1ms. any ideas on what to look for?
and - if I want to setup my network so that I can
ssh somename
instead of
ssh xxx.xxx.xxx.xxx

Should I be using dns? or something else? (I'll probably leave this for 
now until I get everything else sorted, but something to aim for)

Mat.
[trying to learn how to fish and avoiding consultants talking about fish 
meals.]


--
* This is list (humbug) general handled by majordomo at lists.humbug.org.au .
* Postings to this list are only accepted from subscribed addresses of
* lists 'general' or 'general-post'.  See http://www.humbug.org.au/