[H-GEN] motherboard jumpers (pinout)

David Munn djumunn at bigpond.com
Thu May 13 23:38:41 EDT 2004


Hi All...been a while since ive sent a message to HumBug but follow the 
messages on a daily basis and find some "gems" every so often....helps a non 
commercial like me ..Hi Hi

I have aquired a IBM FRU 09N5392 Pro263 M/B  200-05-18 ....my search of the 
web tells me it was used in the APTIVA 2199 series comps....
it has a AMD KD6 500mhz cpu ..sis 530 graphics chip...ESS 1938S soundchip 
...sis 5595 and sis 6801 chips as well...AWARD 1998 PCI/PNP 586 bios....
I want to use it with a standard ATX case and P/S.....however the following 
plugs have got me stumped......

J107 which is next to the main P/S plug...a four pin in line pluug..think it 
may be ibm equiv of the 4 square control plug on the atx supply.....if it is 
i would need the pinouts to make a suitable adaptor.....

J114  a black 2 pin plug on top right hand cnr when vieved with the port 
sockets on left side...suspect this may be the power on/off switch plug

J113 4 pin white plug next to J114 ...could this be the power led and reset 
plug......

have searched the web but cant find the relivant site hence this e-mail....
any help with details or a web site that has the info would be very much 
appreciated....

this board is for a ham radio packet comp to replace an aging pentium 200 that 
runs 24/7  and is very much showing its ange and starting to show little 
gliches that it could go down any time....

Thanking you for your help....

David Munn
VK4BDJ in Sunny Townsville....

Linux forever......





More information about the General mailing list